Roof-wall intersections depend on roofing, flashing, the wall drainage plane, siding and often a gutter working together. Map each junction before work, assign both trade scopes in writing, and require closeout evidence that water is directed down and out.

Map every place the roof meets a wall

The U.S. Department of Energy's Building America Solution Center identifies roof-wall intersections as critical water-control locations. From the ground or another safe location, note each sidewall, dormer, lower-roof-to-upper-wall junction and the point where runoff should enter a gutter. Do not ask a homeowner to climb onto the roof to complete the map.

Record visible staining, peeling paint, damaged cladding or missing-looking diverters without treating appearance as a diagnosis. Some wall claddings can conceal damage, so an apparently clean exterior does not establish that the layers behind it are dry or correctly integrated.

  • Mark every roof-wall junction and its intended drainage path.
  • Save safe-location photos and any prior leak or repair records.
  • Flag hidden, obstructed or disputed conditions for contractor evaluation.

Separate the roofing scope from the wall scope

Step flashing and the end diverter must work with shingles or roof membrane, the wall water-resistive barrier, siding and the gutter. DOE guidance specifically notes that roofers coordinate this work with house-wrap and siding installers. Ask which contractor owns each layer instead of accepting a generic line such as “flash wall.”

The roofer can define roof covering removal, deck conditions and the roof-side flashing integration. The siding or wall scope should address cladding removal and replacement, access to the wall drainage plane and any concealed wall damage. Assign gutter changes separately when the runoff endpoint will move.

  • Name responsibility for roof covering, flashing and roof-side water control.
  • Name responsibility for siding, wall drainage-plane access and restoration.
  • State who handles gutter alignment and concealed wall or sheathing damage.

Write the sequence before tear-off

The proposal should identify which intersections will be opened, whether existing flashing will be removed or evaluated, how siding access will be created and how the finished layers will direct water outward. Product selection and dimensions must follow the applicable roof system, wall assembly, manufacturer instructions and local requirements; the homeowner should not be asked to design the detail.

Set a hold point if the crew finds missing wall layers, rot, incompatible materials or a runoff path that misses the gutter. Require a written change order that identifies the condition, responsible trade, revised detail, cost and schedule before it is covered.

  • List each junction and its planned roofing, wall and gutter work.
  • Define the concealed-condition hold point and approval path.
  • Record required contractor photos before the junction is closed.

Close out the complete drainage path

At closeout, collect contractor-provided photos showing the sequence at representative roof-wall junctions, the finished siding clearance and the runoff path into the gutter where applicable. A surface bead of sealant or a finished-roof photo alone does not document integration behind the cladding.

Keep the junction map, product information, change orders, photos, permits or inspections when applicable and any unresolved limitations with the roof file. If staining or leakage appears later, this record helps the roofing, siding and gutter parties start with the same scope.

  • Collect before, in-progress and finished photos without directing the homeowner onto the roof.
  • Confirm the runoff endpoint and any gutter work are documented.
  • Save unresolved conditions and the party responsible for follow-up.

Related guides

Sources and review

Question frameworks and project-organization suggestions are Roofing Hound’s editorial recommendations. Source links do not imply endorsement. See our editorial approach.

Prepare for the next call

Compare written proposals and prepare follow-up questions.

Build and print a provider-call checklist, or compare local providers.

We can review your project and look for an independent provider. This free service is manual; availability and response time are not guaranteed.

Request free help ↗